Car-Pak 75-4213 Replaced By Auveco 12627 Universal Fusible Link 18 Gauge, Quantity - 5

Product Information

Quantity: 5
Length: 9 in.
Type: Low Tension Cable
Wire Gauge: 18
Made In: Taiwan

A fusible link is a special section of low tension cable installed by an OEM and designed to open a circuit when subjected to extreme current overload. Its purpose is to minimize wiring system damage when such an overload accidentally occurs in those circuits protected by the fusible link. A short circuit causes the fusible link to act as an element in a “slow-blow” fuse. A fusible link is not intended to be used in place of a fuse but only where a fuse cannot be economically employed. Our fusible line wire meets the requirements of SE J-156 and the insulation has the characteristics as listed for EAE, SE J-1128 Type SXL.

The vehicle manufacturer should be consulted about questions on fusible link length and size. General practice has been for a fusible link to be 4 gauges smaller than the circuit wire. Example: if the circuit wire is 12 gauge, use a 16 gauge fusible link. Final determination should be based on O.E.M. application.

Note: Extreme care should be taken to always replace a fusible link with the same gauge and length as installed by the manufacturer.

OEM Cross Reference

Car-Pak: 75-4213
Chrysler: 3843392
Ford: D3AZ-14526-Z

California Prop 65

WARNING: This product can expose you to chemicals including Vinyl Chloride, which is known to the State of California to cause Cancer. For more information go to www.P65Warnings.ca.gov.